Tech Support banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I have an Emachine T1100, Intel Celeron 1.0 GHz, updated to 348 RAM. The system runs rather well BUT.
System will crash and reboot when I run MS Word Processor, Notepad, and while encoding video with Tmpgenc or Nero. Nero does burn video though. It happens every time with these programs after just a couple of minutes running.
Its like I unplugged and rebooted.

Write an event log to system is enabled. But not sure where to find it. Where do I go from here?
 

·
Registered
Joined
·
178 Posts
To check the event viewer got to START-CONTROL PANEL-PERFORMANCE AND MAINTENANCE-ADMINISTRATIVE TOOLS- EVENT VIEWER.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Just checked the log and this is what I get in the Event Viewer.

Under Application I get: EAPOL service was started succesfully

Is this what I am looking for.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #4
This might be it. Under Security I get this Failure Audit:

IPSec Services: IPSec Services failed to get the complete list of network interfaces on the machine. This can be a potential security hazard to the machine since some of the network interfaces may not get the protection as desired by the applied IPSec filters. Please run IPSec monitor snap-in to further diagnose the problem.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top