[bonora]

Hi,,,,
im trying to connect a cat 6 cable from the Ext Nte to the adsl nexuslink 5631 router but i couldn't make the router works for the 2 line i only get one line led on i tried to change the wires colors on the rj11 (4 pins) and even so i cloud not get both led light goes on for tho line and this only for the cat 6 if i hook the old wire i dont know whats kind of wire i think its for inercom or mebe cat3 its works
in the ext Bt only 2 wires connected and on the modem side 4 wires is o nthe rj11 plug i tried to do it the same way with cat6 i only get single line and i do it now with (white-orange=pin 1) (blue-white=pin 2) (white-blue=pin 3) (orange-white=pin 4 ) on the plug , on the bt side i tried to but white -blue with blue-white not working even the opposite.

i just want to know how to wire from ext-Bt to router using rj11-4pin cua thats what my router use on bonding to lines, btw i have only 2 wire on the bt side because i got 2 line phones on a phone line in the bt

 

[Wand3r3r]

Welcome to TSF!

What do you mean by "im trying to connect a cat 6 cable from the Ext Nte to the adsl nexuslink 5631 router but i couldn't make the router works for the 2 line"?

What is ext nte?

Why are you trying to use cat6 when you should be using cat3?

Here is a pinout guide if going from cat3 to 6
RJ11 Telephone - AllPinouts

Unclear what you mean by "2 line" Do you have two adsl lines or just one?

 

[bonora]

ok i have a cafe network was working on 1 line then i want to rise the bandwidth but i cant cuz the phone cant handle it so the company comes n put a second line and the changed the router to nexuslink 5631 that support bonding so they combain the 2 line's, its worked but i'm getting low SNR ABOUT 6.3 DWN 6.1 UP so i see that my networks cables is cat6 but the cable comming from the DB panle = (where u hook the wire from it to the router) is not cat6 i dont know whats is it (ill attach the image of it ), so i i run a new cat6 from db to the router , so know i cant get the 2 line working im getting only one line one the router so 1 LED light is on , i dont know what i did wrong if i get the old wire back both will be one line1 &2 ,,,,from the DB the old wire is connected with only 2 wire (one pair) at the rj11 on the router is hooked with 4 wire's (2 pairs) when i do it with the cat 6 i got only one line on .i heard that the company connets 2 lines in one wire bonding in the router. ill attached the 2 images for the cable ataached to the router and the other end attached to the db panle, why the router cant see both lines.

ty

 

[bonora]

sorry this the attachment

 

[bonora]

ImageShack® - Online Photo and Video Hosting

ImageShack® - Online Photo and Video Hosting

ImageShack® - Online Photo and Video Hosting

 

[Wand3r3r]

Trying to use a cat6 will make no difference. You don't have a wiring problem. You should address this with the ISP's technical support concerning the low snr. This is usually because the line is too long from the central office housing the adsl source.

Your images appear to show a bundled telephone cable.