Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I installed my old Geforce 2 in my dad's computer a few days ago and then remembered yesterday I should change the bios to enable 4x..

After doing so the monitor would not turn on. I then needed to reset the bios/cmos. I pulled up the jumper and put back on to reset. NOw when I boot it up , the white bar for windows xp slides across and then it just freezes there at the end.. I tried resetting the cmos again and got the same result. I took out the gf2 card and still no difference I hope I didn't mess the mobo up.. thanks
 
S

·
Guest
Joined
·
0 Posts
Try starting in safe mode and see if it will boot. Keep pressing F8 at the beginning of the boot process.

Look in the bios and see if plug & play operating system is enabled, If it is try disabling it.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top