Tech Support banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
i cannot get windows or Nero to see my burner as a 48X ...only works as a 16X only..

any ideas..?
 
S

·
Guest
Joined
·
0 Posts
Hi Birdie...................:D

Try this!

Start

Programs

Ahead Nero

Nero Toolkit

Nero DriveSpeed

Detect

See if this helps................................:winkgrin:
 

·
Registered
Joined
·
3 Posts
Try going into the device manager and go to the ide controller properties and enable or disable Ultra DMA if that doesnt work look on neros sight for any patches.

Good luck
 

·
Registered
Joined
·
4 Posts
Discussion Starter #4
the drivespeed detector is only for regular cd-roms that are not yet supported by ahead (nero)..

the problem was solved by a firmware update to the burner and also using 48X rated media..i was sticking in a 12X disk that the software would only let burn at 16X max...

so let that be a lesson to me..i never even thought of getting 48X blanks, but that is what solved the mystery..

thanks for the thoughts/theories

birdie out
 
S

·
Guest
Joined
·
0 Posts
the problem was solved by a firmware update to the burner and also using 48X rated media
This has to be a relatively new burner and they have a firmware update already.

I just installed a TDK 48X a week or so ago what brand is yours?

I always run the drivespeed program just to see if the software detects it as the proper speed.

It took me a few trips to different stores before I found 48X CD's.

But it's good that you solved your problem.................:D
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top