Tech Support banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I'm not sure where to put this question seeming as how there isn't a 'software issue' category, but i'm trying to use ghost 2.0 to create and deploy images to both xp/2k computers. I have just started using the program and i have created a succesful image. However when i go to deploy the image, it runs through the entire deployment, gets to the end and reads 'failed' on the task details paine. Now the computer taking the image simple boots into PCDOS and reads 'sending status info to host', 'status agnoledged by host computer' over and over.

Any ideas? Did i not configure sysprep correctly?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top