Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
When I plug it in with the AC cable the monitor powers on fine, the light is consistently green, and it says "No Signal," then goes back to orange (I assume this is normal).

I tried plugging this monitor in with both digital and analog cables, on two different computers and with each try it stays black, the green light blinks.

I tried changing the resolution as recommended in the manual but that didn't work.
The manual says that I need a ViewSonic Wizard CD to install the drivers but I don't have that, this is a 'junk' monitor that I got from someone else.
Tried looking for drivers online, but they are hard to find.

Is this a hardware or software problem?
What can I do to save this monitor?
 

·
Emeritus
Joined
·
51,675 Posts
Monitors are plug & play. No drivers are need for a monitor to function. I would say the monitor has failed.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top