Tech Support Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
Ok well I am fine for a few hours then out of nowhere nothing will load.
I am able to talk to people on XFire and Ventrilo and my games do not DC me.
BUT if I try to connect to a new ventrilo server or load a page it acts like I do not have a internet connection.

I ran a scan with IE and it gave me this.


Last diagnostic run time: 11/22/09 04:30:19 Gateway Diagnostic
Gateway

info The following proxy configuration is being used by IE: Automatically Detect Settings:Disabled Automatic Configuration Script: Proxy Server: Proxy Bypass list:
info This computer has the following default gateway entry(ies): 192.168.1.1
info This computer has the following IP address(es): 192.168.1.100
info The default gateway is in the same subnet as this computer
info The default gateway entry is a valid unicast address
info The default gateway address was resolved via ARP in 1 try(ies)
info The default gateway was reached via ICMP Ping in 1 try(ies)
info TCP port 80 on host 207.46.193.254 could not be reached (Error code 0x274c)
info TCP port 80 on host 207.46.192.254 could not be reached (Error code 0x274c)
warn The Internet host www.microsoft.com could not be reached
action Automated repair: Renew IP address
action Releasing the current IP address...
action Successfully released the current IP address
action Renewing the IP address...
action Successfully renewed the current IP address
info This computer has the following default gateway entry(ies): 192.168.1.1
info This computer has the following IP address(es): 192.168.1.100
info The default gateway is in the same subnet as this computer
info The default gateway entry is a valid unicast address
info The default gateway address was resolved via ARP in 1 try(ies)
info The default gateway was reached via ICMP Ping in 1 try(ies)
info TCP port 80 on host 207.46.192.254 could not be reached (Error code 0x274c)
info TCP port 80 on host 207.46.193.254 could not be reached (Error code 0x274c)
warn The Internet host www.microsoft.com could not be reached
action Automated repair: Reset network connection
action Disabling the network adapter
action Enabling the network adapter
info Network adapter successfully enabled
info This computer has the following default gateway entry(ies): 0.0.0.0
warn There is no default gateway entry
action Manual repair: Reboot modem
info This computer has the following default gateway entry(ies): 192.168.1.1
info This computer has the following IP address(es): 192.168.1.100
info The default gateway is in the same subnet as this computer
info The default gateway entry is a valid unicast address
info The default gateway address was resolved via ARP in 1 try(ies)
info The default gateway was reached via ICMP Ping in 1 try(ies)
info TCP port 80 on host 65.55.21.250 could not be reached (Error code 0x274c)
warn The Internet host www.microsoft.com could not be reached
info Waiting some time for the modem/router to stabilize
action Automated repair: Renew IP address
action Releasing the current IP address...
action Successfully released the current IP address
action Renewing the IP address...
action Successfully renewed the current IP address
info This computer has the following default gateway entry(ies): 192.168.1.1
info This computer has the following IP address(es): 192.168.1.100
info The default gateway is in the same subnet as this computer
info The default gateway entry is a valid unicast address
info The default gateway address was resolved via ARP in 1 try(ies)
info The default gateway was reached via ICMP Ping in 1 try(ies)
info TCP port 80 on host 207.46.192.254 could not be reached (Error code 0x274c)
info TCP port 80 on host 207.46.193.254 could not be reached (Error code 0x274c)
warn The Internet host www.microsoft.com could not be reached
info Redirecting user to support call



IP Layer Diagnostic
Corrupted IP routing table

info The default route is valid
info The loopback route is valid
info The local host route is valid
info The local subnet route is valid
Invalid ARP cache entries

action The ARP cache has been flushed



IP Configuration Diagnostic
Invalid IP address

info Valid IP address detected: XXXXX



Wireless Diagnostic
Wireless - Service disabled

Wireless - User SSID

Wireless - First time setup

Wireless - Radio off

Wireless - Out of range

Wireless - Hardware issue

Wireless - Novice user

Wireless - Ad-hoc network

Wireless - Less preferred

Wireless - 802.1x enabled

Wireless - Configuration mismatch

Wireless - Low SNR




WinSock Diagnostic
WinSock status

info All base service provider entries are present in the Winsock catalog.
info The Winsock Service provider chains are valid.
info Provider entry MSAFD Tcpip [TCP/IP] passed the loopback communication test.
info Provider entry MSAFD Tcpip [UDP/IP] passed the loopback communication test.
info Provider entry RSVP UDP Service Provider passed the loopback communication test.
info Provider entry RSVP TCP Service Provider passed the loopback communication test.
info Connectivity is valid for all Winsock service providers.



Network Adapter Diagnostic
Network location detection

info Using home Internet connection
Network adapter identification

info Network connection: Name=Local Area Connection, Device=Realtek RTL8168/8111 PCI-E Gigabit Ethernet NIC, MediaType=LAN, SubMediaType=LAN
info Network connection: Name=Internet Connection, Device=Internet Connection, MediaType=SHARED ACCESS HOST LAN, SubMediaType=NONE
info Ethernet connection selected
Network adapter status

info Network connection status: Connected



HTTP, HTTPS, FTP Diagnostic
HTTP, HTTPS, FTP connectivity

warn FTP (Passive): Error 12031 connecting to ftp.microsoft.com: The connection with the server was reset
warn HTTPS: Error 12029 connecting to www.passport.net: A connection with the server could not be established
warn FTP (Active): Error 12031 connecting to ftp.microsoft.com: The connection with the server was reset
warn HTTP: Error 12002 connecting to www.microsoft.com: The operation timed out
error Could not make an HTTP connection.
error Could not make an HTTPS connection.
error Could not make an FTP connection.


This is not just a Firefox or IE problem anything that connects to the internet has this problem.
 

·
Global Moderator
Electronic Design
Joined
·
52,320 Posts
Once it fails, please do the following tests.


Try these simple tests.

Hold the Windows key and press R, then type CMD (COMMAND for W98/WME) to open a command prompt:

In the command prompt window that opens, type type the following commands one at a time, followed by the Enter key:

NOTE: For the items below in red surrounded with < >, see comments below for the actual information content, they are value substitutions from the previous IPCONFIG command output! Do NOT type <computer_IP_address> into the command, that won't work. Also, the < and > in the text is to identify the parameters, they are also NOT used in the actual commands.

Do NOT include the <> either, they're just to identify the values for substitution.

IPCONFIG /ALL

PING <computer_IP_address>

PING <default_gateway_address>

PING <dns_servers>

PING 74.125.45.100

PING yahoo.com

Right click in the command window and choose Select All, then hit Enter to copy the contents to the clipboard.
Paste the results in a message here.

<computer_IP_address> - The IP Address of your computer, obtained from the IPCONFIG command above. (For Vista/Win7, the IPv4 Address)

<default_gateway_address> - The IP address of the Default Gateway, obtained from the IPCONFIG command above.

<dns_servers> - The IP address of the first (or only) address for DNS Servers, obtained from the IPCONFIG command above.

If you are on a machine with no network connection, use a floppy, USB disk, or a CD-RW disk to transfer a text file with the information to allow pasting it here.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top