Tech Support banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have been trying to see what kind of negotiations (full or half duplex), a VOIP network device (Linksys Pap2) is setting up. I have connected the Voip device to a hub, and connected my pc to the same hub. I am using ethereal. Please help.
 

·
Citizen of the world
Joined
·
51,137 Posts
Well, it clearly runs full duplex I would imagine. I'm not sure what kind of help you're looking for here. Can't you see any traffic?
 

·
Citizen of the world
Joined
·
51,137 Posts
Well, it's all going to be IP traffic, but I don't know the intimate details of the VoIP operation. What are you trying to accomplish?

I'd think a better way to learn about the operation is to find a paper on the operation of VoIP, I'm sure there are tons of them on the web.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #7 ·
I am familiar with VOIP and suspect that it is a networking/link layer protocol like BACnet that initiates the negotiations. Anyone else?
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top