Tech Support Forum banner
Cancel

TITAN DDR + LanParty NF4

948 Views 5 Replies 3 Participants Last post by  federicog, 
F
My mobo is a LanParty NF4 UltraD. I just bought two 1gb Titan DDR400 modules. I installed them and the computer boots, but it freezes after a few minutes. I ran memtest and it reported many errors.

Are the modules faulty or is it possible that they need to be manually configured in the bios? I was using two ocz modules that only worked ok when manually set up. If that's the case, where can I find the correct values for the titan modules?

The computer works ok with the ocz modules, I removed them to check the new modules.

Thanks!!
Save
Like
Status
Not open for further replies.
1 - 6 of 6 Posts
Tyree
If MemTest showed errors then I would assume the RAM is faulty. I've never known Memtest to produce faulty results.
Save
Like
F
Thanks, I tried several configs and memtest always reported errors, so I will be returning them tomorrow for a replacement.
Save
Like
speedster123
You need to install quality ram with that board, such as corsair xms.
Save
Like
F
Yeah, I know, but right now it's a little hard to find a great variety in ddr where I live (most places sell ddr2 and 3).
Save
Like
F
I just replaced both titan modules and everything is working just fine. Memtest threw no errors and no freezes. Also, I could boot the pc with all four modules plugged in, so it seems that all the problems were due to the faulty titan modules.
Save
Like
1 - 6 of 6 Posts
Status
Not open for further replies.
Tech Support Forum
A forum community dedicated to tech experts and enthusiasts. Come join the discussion about articles, computer security, Mac, Microsoft, Linux, hardware, networking, gaming, reviews, accessories, and more!
Full Forum Listing
Explore Our Forums
Windows XP Support Windows 7 , Windows Vista Support Motherboards, Bios|UEFI & CPU Networking Support Laptop Support
Top