Tech Support Forum banner

This has me stumped!

747 Views 3 Replies 3 Participants Last post by  dai
:4-dontkno

*New MB.
*New monitor.
*New graphic card.

Power to board, seems to be booting ok, however there is no image getting to the monitor.

Plug monitor in and on start up the "No Signal" sign goes, however after not even a minute it returns?


Help please this is driving me mad.
Status
Not open for further replies.
1 - 4 of 4 Posts
If your motherboard has an onboard video card, plug your monitor into it, start you computer and see if that works, if it does then go to your BIOS and make sure that the AGP slot is enabled.
Done that and still no response to monitor :4-dontkno
is the p/s big enough to run the system check here
http://www.jscustompcs.com/power_supply/
based on a quality supply and add 30% to the result
1 - 4 of 4 Posts
Status
Not open for further replies.
Top