Tech Support banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I have a power supply that may have caused the death of a mb and 2 video cards. Is there a way to test it without it being conected to a mb? While still connected to the board which i believe it killed i measured 6.3 v and 14.9 v at one of the output connectors. I don't know what is considered acceptable but another supply i have measures right on at 5 v & 12 v
 

·
Registered
Joined
·
11 Posts
Discussion Starter #3
DUHH--- what I'm asking is 1. are the voltages I measured too high? 2. which pins on the MB connector have a known voltage without a MB to switch the power supply on?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top