Tech Support Forum banner
Status
Not open for further replies.
1 - 4 of 18 Posts

· Registered
Joined
·
89 Posts
Discussion Starter · #1 · (Edited)
Hi, i recently built my new machine and was wondering about the temps it should run at.

the specs are

2600+ AMD Athalon XP
Gigabyte GA-7VA-C
512mb DDR333 Ram

it runs at about 40C idle and about 50C full load.

is this normall or a bit high, if its high how can i get it down, it is cooled by two fans, yourl see how below but if it is still runnning hot how can i get it down?



p.s that image was large ill try this one
 

· Registered
Joined
·
89 Posts
Discussion Starter · #8 ·
madeyalook said:
how do i find out my cpu's temp?
Well madeyalook, you can normally see your system and CPU temps in the bios, under the heading PC health status or something along those lines
 

· Registered
Joined
·
89 Posts
Discussion Starter · #10 ·
hi,
this made me chuckle, while reading through my mobo manual i came across one of the features, it says that when the CPU reaches a critical temp the system shuts down. oOo i thought might be handy, untill i read down the page the temp the cut off is set at on my board is 110C. Hmmm i think it may have cooked by then.....
 

· Registered
Joined
·
89 Posts
Discussion Starter · #15 ·
hmmm, 65 for a 450 seems hot too me, i used to be able to get my 1.0ghz duron to run at 30c idle and 35c full load.
 
1 - 4 of 18 Posts
Status
Not open for further replies.
Top