Tech Support banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter #1
Hi,

Have recently attempted to intall an external fax/modem to connect to our business bank. Driver gets halfway through install and bluescreens, every time. With this half installed it works fine so im fine leaving it as it is.

However every time I boot I get the found new hardware wizard. If anyone else uses the computer they will click next and hit the bluescreen. Is there any way of disabling the prompt but only for the modem.

I tried stopping the plug and play service but that stopped my usb flash drive from working.

If not then what on earth can I do about this bluescreen install, have tried unistalling and re.. a million times.

Thanks, Leigh
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top