Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 · (Edited)
When I start up my Dell Dimension 8200, I get an error message that says: "Drive 1 Primary EIDE controller is operating outside of normal specifications" and directs me to replace HDD. I had originally (year ago)replaced the original hard drive after a power supply failure with a new W.D. and put the original back in as a slave. Any suggestions other than tossing the W.D. hard drive? Can I transfer everything to the slave hard drive and is there an "simple" way to do that? Thank you!
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top