I purchased a bare bones system with an Athlon 64 7750 processor and a biostar mcp6pb m2 GForce 6150 chip set. It was tested at the factory (don't know the display settings they used). When I installed my HD which has win XP the system boots up but my starlogic monitor says out of range. It tells me to (in the manuel) to change the display settings and refresh rate to 1024 x768 and the refresh rat at 60HZ . I am not able to do that. My old graphics card is AGP not supported by this motherboard. I have a spare HD which i can boot up and put win xp on from scratch. Will I then be able to set the display settings to the proper range? The monitor displays the CMOS and I can get in there but as windows boots I get the out of range message. Thanks in advance for your help.
John
John
