Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1,481 Posts
Welcome to the board...dont worry about getting you legs kicked out till you been here a while:angel: -even then it is all in fun...good thing i have my arms or I would REALLY be in trouble:winkgrin:

OK

so is this drive new or old


Idealy...other will be more persise but here we go

open case...put drive on cable...check jumper setting and insure the main -boot drive is set to master and the new drive is set to slave...seat cable and reseat them to make sure theare secure...


when you boot enter your BIOS -del or F1 or something to that effect...it should say at boot up...go to IDE auto detection and see if the drive are found...if they are great...if not check your cables, jumper settings power connections


when you boot up and go into my computer the new drive letter should apper...the first time you go to use it windows is going to ***** it is not formatted...then do it for you...when its done your done...

Good luck and stick around
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top