Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a Symantec 320 Security Firewall, SBS2003 Server with two Ethernet adapters. This is how I set it up, I can get to the Internet OK on all workstations but I can't Ping out of the LAN addresses. I can't ping 192.168.0.1 which is the SGS320 Firewall.
Can someone tell me what I am doing wrong?
This is my setup:
---------------------------------------------------------
SGS320 Security Appliance Firewall
WAN port
IP address: per ISP
Default Gateway: per ISP
DNS1: per ISP
DNS2: per ISP
--------------------------------------------------
LAN port
IP address:192.168.0.1
Submask:255.255.255.0
DHCP : not enabled
--------------------------------------------------
SBS2003 Server
Server WAN NIC
IP address: 192.168.0.55
Submask: 255.255.255.0
Default Gateway: none
DNS1: 192.168.0.55
DNS2:
NetBIOS over TCP/IP enabled

Server LAN NIC
IP address: 192.168.0.45
Submask: 255.255.255.0
Default Gateway: 192.168.0.1
DNS1: 192.168.0.55
DNS2:
NetBIOS over TCP/IP enabled

SBS2003 - DHCP server enabled
----------------------------------------------------
 

·
Registered
Joined
·
40 Posts
Change the default gateway for the LAN side to the server IP address and the add in the IP address of the firewall as the default gateway for the WAN side of the server.

This should give you internet access and allow you to ping the firewall from the LAN side.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top