Tech Support Forum banner

S-10 no start

705 Views 2 Replies 2 Participants Last post by  Sparkiee6
97 s-10 4.3l original problem crank but n o start went through start system new plugs and wires new distributor cap and rotor new camshaft sensor and crankshaft sensor. new fuel pump and filter also new fuel pressure regulator and manifold gasket. Finally got it to start after resetting timing was 180 out, started an ran for 30 mins. turned it off restarted. Son put bed back down on frame started vehicle it ran about 1 min sputtered and quit. lifted up bed checked wiring all looks good but no start and only getting 5volts to ground strap at pump gray wire. Is there a dedicated ground for the pump if not what is the problem.
Status
Not open for further replies.
1 - 1 of 3 Posts
If timing was 180 out perhaps the timing chain and gears are worn and slipping. How many miles?

Also, you said you replaced the fuel pump and regulator but did you check the fuel pressure after? If so, what is it?
1 - 1 of 3 Posts
Status
Not open for further replies.
Top