Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
248 Posts
If you are using a cisco router to join the two LAN segments, use the:

Router <config-if>#speed <1-100000>

This command will physically change the speed on the port. If you are using a routing protocol such as EIGRP or OSPF you will also need to use this command to identify to the protocol that the line speed is differant from the default:

Router <config-if>#bandwith <1-100000>

Make sure that the speed you slect with the "speed" command is also reflected in the "bandwith" command, if not you will have routing issues if you have redundant links or are using load ballancing.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top