Tech Support banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
256 Posts
Discussion Starter · #1 ·
Linksys LNE100TX Faster Ethernet Adapter v1.0 #2

Originally, I had another NIC that works fine and dandy. I cleared it's addresses and uninstalled its drivers before I turned off computer. THen i replaced the old NIC w/ the LNE100TX. It is detected in windows with properly installed drivers but unable to communicate to router or neighboring computers in the LAN. I pinged it's ip address its fine but other addresses like the router won't work. THe cables are all hooked in because the lights are lit up at the back of the LNE100TX. I fear it is defected but on the other hand it was the factory card that came with my DSL and if the LNE100TX is connected directly to the DSL it would go online (via EnterNET stock program) but would not be able to communicate with other NICs in the LAN or the router. If I hooked both NICs in the same computer the LNE100TX doesn't work but the other one will. If i swap again and again the LNE100TX still wouldnot work but the other one would still work. What could be the problem? And what can I do?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top