Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
XPpro, ntfs, 80g IDE wd's 8m x2, ITE giga-byte onboard ata133 raid.
Setup as bootable Stripe. both disks are master, on separate channels. latest drivers, right cables.
Imaged o/s install with ghost using an old 40g 5400(didnt have cash to buy two drives at once) 80g >image on to 40>build raid with 2 80's>initilize disk in xp>image off 40g onto raid>set raid to boot.
It all seems fine i have my single 149g "ITE disk array 0 SCSI disk device" in device manager.
but when i did a file system benchmark in Sandra 2003 i get slower than used to get with my single 80g.
hd tach reports 15ms access, 35 mb/sec sequential read.
have i forgotten to check some type of DMA setting?
thanks for any help!
 
S

·
Guest
Joined
·
0 Posts
Welcome to the forums nimh......................:D

I have only set up a few RAID arrays in my days but have always done a clean install of the OS.

When you where ghosting over to the RAID array did Ghost recognize the full size of the RAID array?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top