Tech Support Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
223 Posts
Discussion Starter · #1 ·
I recently used Acronis Migrate to upgrade from an Ibm 20gig to a Western Digital 40 gig Primary drive. In my old systen i had the Ibm 20 gig primary with a Western Digital 40 gig slave. I had an identical Western Digital drive in another coputer that i tore down for parts and decided to upgrade. System boots fine and runs normaly on the new drive, exactly as it did before, but i cannot access my slave drive. It goes thru hardware detection and installs it, as well as it shows up in the hardware wizard, but it does not show up on my computer as it being there. My computer specs are:

Amb Athlon 1700+
Asus Kv7-turbo mobo
512 Mb Kingston Ram
128 mb Raedon Video card
lite-on cd-rw
and dual western digital WD400BB-60DGA0
 

·
Premium Member
Joined
·
8,700 Posts
After it installs go into computer management and see if it there and if it has a drive letter assigned to it, if it is there with no drive letter assign one to it and reboot and see if it is there
 

·
Registered
Joined
·
1,246 Posts

·
Registered
Joined
·
223 Posts
Discussion Starter · #7 ·
My problem isnt that i cannot access the drive, The drive isnt showing up under my computer as even being there, but under the device manager, it shows it being intact and working properly
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top