Tech Support Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Hi
I have a Gigabyte GA-K8VM800M mother board in my PC and at the moment there is one 512MB module fitted into slot 1.
I have obtained another 512 mod and have tried to fit it into slot 2.
The modules are the same.
All I get when I reboot the PC is one of two things. Long single Beeps, or sometimes it will start to boot into the PC Heath screen and then stops.
I have tried the module that I tryed to put in slot 2, in slot 1 and it boots up fine, as soon as I put the mod that was in slot 1 into slot two, it fails again.
Either of the mods work fine in slot 1 but neither work in slot two.
Any Ideas
Cheers Chris
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #5 · (Edited)
Yeah slot two doesn't seem to work, could be dirt, I have given it a good blow out but think 1 pin looks a bit dirty will try to clean and try again.If I can't get it to work may just try to get a 1gb for slot 1 or maybe a whole new PC this one is about 5 years old.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top