Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
G'Day

After successfully installing a Cannon ip 4200 and after a failed install of other programs I had to roll back the windows to the "last system settings that worked". When installing the new printer driver it comes up with numerous errors depending on which method I use to install the driver.

My Question:

Can anyone tell me how to get the printer driver into a fresh state so I can re-install it?

Thanks.
 

·
Banned
Joined
·
2,854 Posts
Uninstall the Printer driver in Add Remove Programs. Download Glary utilities and run the defaults. Then go to Start/Run and type CMD and hit enter. in the command prompt type chkdsk /f/r and hitr enter Then type Y and reboot your computer. The Check Disk utility starts at next boot up to correct any errors.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top