[mazzie1962]

I installed a replaced a linksys wrt54g with a wrt330n with no problems. All 3 laptops online. I tried to install a wpsm54g wireless printserver and none of the pcs see the printserver and neither does the installation wizard. When i reset the ps, it prints a test page but nothing sees the ps. When the test page prints ip, gateway, etc are "0.0.0.0" How can i fix this?

 

[blackbox_ns]

The ethernet port on the WPSM54G is for configuring the unit, and since the wireless side hasn't been configured you will not be able to get access via wireless. You may want to connect the wired ethernet port on the print server to a wired LAN port the router (this is temporary until the print server is setup) and try running the installation wizard again.

 

[johnwill]

Yep, you can't really configure most wireless equipment over the wireless link for what should be obvious reasons. :smile:

 

[cdzo72]

yeah, sounds like you're not following through with the entire set up process

 

[james.snv]

Hi,
I think you are not following the entire process.

 

[johnwill]

Time to close this one, it's two years old!