Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Ok, i'm sure half of you have already seen enough threads about the power save mode problems, i've read each of those.

My problem is;

Old monitor breaks and i find a replacement, a dell monitor. I plugged it in and it worked fine, i then powered down the pc and left the monitor on stand-by. My other monitor normally switches itself off after being in standby for a short period.

I tried to boot up today and the monitor didn't display an image, so i pressed one of the colour settings on the monitor and i got the 'power save mode' text come up.

I've unplugged the monitor, checked the connection to the computer etc...


I've made no changes in the BIOS or control panel. I shutdown as normal, but left the screen in standby...

Any tips to fix this?
 

·
Registered
Joined
·
30 Posts
What is your graphics card ? on mother board, PCI, AGP , xpress ?

I have already seen this kind of strange behaviour et bios parameters was changed , why i do not know.
Try to put off and put on the battery of your PC in order to reset bios parameters.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top