Tech Support banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1 (Edited)
I have 2 sticks of 256 MB OCZ, Dual Channel Optimized RAM. According to SANDRA, I should be able to reach a band width in the 4800s.

The best I can do is 4200 without MemTest86 giving me errors.

Come hell or high water, I cannot set the "Performance Mode" to STANDARD (use PAT) - I have to leave it at AUTO. If I do set it to STANDARD, I get MemTest86 errors. However, this setting is required for me to reach the SANDRA bandwidth spec.

Anyone here knows what's going on? The RAM tests out fine in single channel mode - even at 2-2-3-6.

:confused:
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top