Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a P4P800, 2x Infineon 500MB DDR PC3200 in the blue slots. When I start up, I get blank screen, though drives spin, etc. Then, I restart (power button) and the system POSTs, but then stops just prior to starting the OS boot with a message that overclocking failed. I can press F1 to go to setup, or F2 to continue with defaults. F2 gets me into Windows, but this is annoying.

Thing is, the bios is set to all defaults already. I've tried setting every manual setting to the slowest possible just to see if it might work, but no luck. Same issue every time :confused:.

Any ideas what else I might try?
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top