Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
I'm having the same problem.

I press the 'del' key to get into setup.

It gives the message: "starting setup", but doesn't. It's seems to start normally, then I get a message about scanning for IDE drives and then nothing. The monitor gets no signal and nothing happens.

I tried powering on and off and after about 20 tries I was able to get into the bios.

I've updated the most current bios version 1008.

Anyone have any ideas?

I would like to get into the bios to turn of the RAID stuff and to set the hard drive to 32 bit mode.

Thanks,

Laz
 

· Registered
Joined
·
2 Posts
What will resetting CMOS do? Will that restore the original BIOS version?

If I don't try and enter setup (ie don't press anything), my computer starts normally.

I just can't get into the BIOS to make any changes.

Strange?

A friend with the identical computer is having the same problem.

Hmmm. Any help appreciated.

Thanks,

Laz
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top