Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I'm doing my first build and am at a bit of a loss.
My old dead machine was a Dell XPS 710 and I'm swiping the Creative X-Fi sound card from it.
New set up is a
Intel Core 2 Duo E6700 2.6MHz processor
ASUS P5G41T-M LX2/GB LGA 775 G41 mATX Motherboard
CORSAIR 4GB 2X2KIT DDR3 1333 RAM

My question is upon installing the card I went to use the cable than ran from the card to the mobo in the XPS. It was a 10 pin cable completely flat (all pins in a row). I can't find for the life of me if this needs a cable to go to somewhere on the mobo or just attach and boot it up.
I did DL the drivers I have on a jump drive when I go to install the rest of the drivers on the new system.

Does this sound familiar to anyone?
Thanks!
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top