Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
after searching the web numerous times, this thread comes the closest to reflecting a big problem with my new vid card.

I just bought a PowerColor Radeon 9600 Pro 128 meg. I have a Samsung 570V TFT LCD panel monitor with an analog VGA interface.

But... I am getting this "Auto Adjustment Locked!" message and I can't change any of the settings on my monitor anymore. This never happened on my old Asus Geforce GTS card.

I've tried the DVI connector with the included VGA adapter, I've tried unplugging the SVIDEO-out cable to my TV, I've even tried the unlabelled jumper on the card... which was a good thing, as the card now displays both TV out and VGA while booting, where before it only displayed to SVIDEO on boot-up (until Windoze booted and then it switched to VGA).

I sent PowerColor an email but I expect the usual horrid tech support from this Taiwanese company... ****, I really should have bought a "made by ATI" card.

any help appreciated.. the only thing I can think of is to rip-out the DDC pin on the monitor but that seems extreme and I am not sure if it will work.. heck I am not even sure if there is a specific pin for the DDC info.

EDIT: ack, a call to Samsung and we're back in business.. seems the menu was locked :dead: press and hold MENU key for 10 seconds and all is well again :sealy:
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top