Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
1,397 Posts
Along the lines of what Der Robe is saying, if the other end is unplugged or the port is disabled, Winders will think the "cable is unplugged".
 

· Registered
Joined
·
1,397 Posts
Have you tried moving the cable to another port on the hub? Possibly:

A.) the port you're using is bad
B.) The port you're plugged into is an MIDX (cross over port)
C.) You might have a cross over cable.

Is it the same cable you've been using for a while (known good working cable)?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top