Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Dear all,

I'm trying to setup port forwarding on my ZTE-F609 Modem and my TP-LINK (Archer D9) but i can't seem to set it up properly. The portforwarding is to allow remote access to my NVR.

Here is my setup:
ZTE-F609 (LAN)------> TPLINK D9 (LAN)------> SWITCH----->PC + NVR

ZTE-F609 (LAN: 192.168.2.1, DHCP ON 192.168.2.100 - 253)
http://s32.postimg.org/8wl3reu91/ZTE_DHCP.jpg

TPLINK D9 (WAN: 192.168.2.2, LAN: 192.168.1.1, DHCP ON 192.168.1.100 - 200)
http://s32.postimg.org/ws26p8gpx/TPLINKD9_WAN.jpg
http://s32.postimg.org/a779palr9/TPLINKD9_LAN.jpg

PC (LAN: 192.168.1.200)
NVR (LAN: 192.168.1.10)

PORT FORWARDING ZTEF609:
http://s32.postimg.org/gc7eznmp1/PORTFORWARD_ZTE.jpg

PORT FORWARDING TPLINKD9:
http://s32.postimg.org/t62pkr6hx/PORTFORWARD_TPLINKD9.j...

When i tried to check my public IP from the PC, the public IP is different from the public IP of my ZTE-F609 modem-router, I also did a check from canyouseeme.org for ports 8080, 8100, 8554, they are still closed...

Could anybody point out what i did wrong...? What should be the best setup for my situation?

Thanks in advance...:thumb:
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top