Tech Support Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
289 Posts
Discussion Starter · #1 ·
adding win98se to win2k pro, adv server dual boot set up
Here's the deal. I'm in an MCSE class at night, I get evaluation copies of win2k O/Ss (120 day limited). I clear my H/D of my home built and set up 4- 2GB partitions c: is pri active with win2k pro now, d: is adv server, now I want to put Win98se back in to stay permanent. I start with the boot disk for98 but the O/S only wants to go to C: (it is FAT) where there is not enough space even if it would be ok with pro there. Is there a way to get it to load in another partition than the C: primary? It's no big deal to kill the pro but I just want to "Know". Thanks
:confused:
Please excuse me for not putting this in the forum first.
 

·
Registered
Joined
·
289 Posts
Discussion Starter · #3 ·
Many Thanks

An instructor had said to install the Win 2k first. Something about how it would set up the boot ini for the multi boot config, I just didn't consider at the time that win2k didn't have the DOS base for win98, I'll pull win2k pro off c: now, I'll get back on line when done. Enough said I learned from it.
Thanks again! Top Tech
My Regards to Texas
TCH:sleep:
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top