Tech Support Forum banner
1 - 20 of 20 Posts

·
Registered
Joined
·
441 Posts
Discussion Starter · #3 ·
right, I got a dvi-d cable and the monitor is connected to my pc now but its touch facility still doesn't work.

where could I get an installer for the monitor?
 

·
Registered
Joined
·
441 Posts
Discussion Starter · #9 ·
thanks for that. I've bought a couple of cables online, now, so....just a matter of waiting 'til I receive 'em to see if they're right.

I need to get a stand too. got any links for that?
 

·
Registered
Joined
·
441 Posts
Discussion Starter · #14 ·
I got a stand and a cable from amazon today and neither of them fit. the holes in the stand align with the monitor but the screws don't screw in.

the cable is a total non-starter - it doesn't fit into the socket on the monitor at all.

so, what to do? I haven't checked that last site out yet....maybe I'll get something there. doubt it but, I'll try....
 

·
Registered
Joined
·
441 Posts
Discussion Starter · #34 ·
thanks for all of that info but I've actually just bought some more screws which might work - I measured the depth of the hole which ahem I didn't do before ahem :p so, hopefully, that'll make a differene!

I'd got a 20mm screw before and now I've ordered a 14mm screw.
 

·
Registered
Joined
·
441 Posts
Discussion Starter · #41 ·
it's a iiyama Prolite T1531SR touchscreen. everything else on it works except there is no expand facility.

it doesn't do anything when I use two fingers and expand outward, btw. that's what I'd like to enable.
 

·
Registered
Joined
·
441 Posts
Discussion Starter · #43 ·
no, those don't work. my monitor is listed as a Generic PnP Monitor, btw.

I've just seen Tablet PC settings and....hmmm....I didn't get very far with it. when I touched the screen (when it asked me to) nothing happened. zilch. is that relevant?
 
1 - 20 of 20 Posts
Top