Tech Support Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 · (Edited)
So I recently changed my mobo/cpu from a Intel ESC 945P-A and intel pentium 4 to a Asus M3A78-EM and AMD Athlon 2 Kuma 2.7GHz or something like that. It's Socket AM2 at any rate.

I've changed nothing else in my system. The RAM, HDD, DVD Drive, Video Card, PSU, all the same.

The problem is my monitor is getting no signal from anything. It was working when I had the intel stuff in it, now it's not. What do I do to fix it?

Here's what I've done so far:
Re-seated the video card
Removed and replaced power to mainboard/cpu.
Switched which slots the RAM is in.

The mainboard is getting power, because I can see the LED on it lighting up. So it's not a short of an issue with my power supply.

Anyway, the heck is wrong with it?

Here's the specs:
AMD Athlonx2 Kuma CPU 2.7GHz thing
Asus M3A78-EM mainboard
OCZ 1GBx4 DDR2 800 RAM
XFX GeForce 9500GT
Some random 650 watt PSU I got off ebay
Sony DVD/CD-R Drive
NZXT Rogue case comes tomorrow. Currently in a **** case.
Seagate Green 500GB HDD

Thanks for replies
 

·
Emeritus
Joined
·
51,675 Posts
Are you certain the Mobo standoffs are all in place?
Do you have ALL the requires power plugs connected to the Mobo?
 

·
Registered
Joined
·
37 Posts
Discussion Starter · #4 · (Edited)
Here are the combinations of components I've just tried.

everything minus ram
everything minus ram/dvd
everything minus ram/dvd/hdd
everything minus ram/dvd/hdd/gfx card
everything minus ram/dvd/hdd/gfx card/case
every minus case
re-seated cpu just now once i put it back in the case i'mma try again.

And I built it into a card board box and tried it with everything
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top