[makaiman]

Hi everyone,
I've a Korean Computer, brand new, running Windows 98' in it. It is a "Safer" Computer (that's the name of it), and it has a 13 flat panel monitor. Well, my problem is when I turn on the computer and then the monitor the monitor remains black with nothing coming up. I've made sure all the connections are correct as I've used it before. However, I get this blinking light after I turn the monitor on and can't go past that to normally load or get even into my Bios? Could the monitor be on standby? And if so, how do I get it out of standby? Moreso, how can at least get to the point of seeing something on the monitor? Please let me know. Again, video card and all connections are working fine, but now I just don't have a thing on the monitor with a blinking green light. Thank you for all of your help anyone...

 

[SPEEDO]

Welcome makaiman...........

Did this monitor ever work while in your possession?

 

[Volt-Schwibe]

hmm

a couple of things i can think of could be doing that.

check to see that all the pins in the plug are not pushed into the plug. sometimes they fall into the plug and dont reach into the hole anymore, and some of the pins are the ones that tell the monitor to wake up and sleep.

also, sometimes the monitor itself stops working correctly, and it will no longer respond to the Dpms. try borrowing a different monitor, or try that monitor on a known working machine.

and make sure the video card is fully seated.

Does the pc seem to run other than not being able to see?

as far as bios settings, i think its the insert key on most machines, you have to hold insert at a certain point and it resets the bios defaults.

i hope this helps at all.


~~BoB~~

 

[makaiman]

Monitor Doesn't Come on and blinks (Again)

Thank you for all of your replies. I have tried three different monitors, two brand new video cards, and with this new computer and everything appropriately plugged in, I still get no video display even to get into the Bios. All three different compatible monitors work fine on all of my other machines, but not the one previously mentioned above. The monitors just seem to stay "black" and nothing, no text or anything appears accept either a blinking light or the monitors (all three) go into this standby mode perhaps. I just want to SEE TEXT OR SOMETHING ON THE SCREEN!! eek! Someone help. All connections are new and everything works, save for the fact of being able to see something on the screen. Hope someone reads my first post on this.. It is urgent...
Michael

 

[makaiman]

Please Help me Speedo Sir!!

Welcome makaiman...........

Did this monitor ever work while in your possession?

:no:

I need your help. Please see my reply or my last one. Tried three different monitors, two new video cards and nothing on the screen...See my first post and last reply...thank you so much..

M

 

[SPEEDO]

You say this computer is brand new but it doesn't work, Right!

Why don't you just return it because it's defective?

 

[makaiman]

Thanks for a quick response...

You say this computer is brand new but it doesn't work, Right!

Why don't you just return it because it's defective?

The issue is that it is not my computer. I am a consultant and can usually overcome these types of issues. It is a computer of another client in this particular, and I was told that a new power supply was put into it the other day from "COMPUSA" for some compatibility issue for the computer being here in America. Could this be the problem? I looked closely at the powersupply and it seems fine. Another thing is that one usually here's a "Beep" upon start up. These computers are very similar to Dell's and Gateway's...Can't figure this one. Just dying for a display...
Thanks for any future thoughts here...