Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
i need help.
I am currently running a 160gig hard drive with Windows2000 running on NTFS. this is the only drive installed at this time. but i also have another 60gig hard drive with mandrake linux 9.1 fully installed on it. how can i install the 60gig hard drive as a slave and dual boot the operating systems. i am a newbie for linux so i dont really know too much about it.


another question taht isnt really related. i have a microsoft wireless network adaptor mn-510. how can i set it up in linux. i put the installation cd in, but that didnt help any. it comes up listed as a scanner, so im not sure what the deal is.

thanks in advance
 

·
Registered
Joined
·
711 Posts
You'd need to configure the bootloader to dual boot. Do you know if you're using LILO or Grub on the linux system?

As far as the MS wireless card goes, I highly doubt its supported under linux but if you know the chipset then I'll help you find out.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top