Tech Support Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
i purchased a FIC K8MC51GLF w/ a 3200 sempron i put 1g ram in it from my system and connected the monitor to its onbaord port im using a dynex 400w ps all i get is a beep 1 beep pause 1 beep no change after 5 mins plz help
 

·
Emeritus
Joined
·
51,675 Posts
That Beep Code is probably a RAM problem but could be a circuit failure.
Specs of the 1GB RAM stick you used?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
the ram is from wintec bought on newegg ampo ddr 400mhz i pulld a stick from my existing system that does work i bought that MB/cpu combo as a just in case type deal its pheonix bios and they dont have a 1-1-1-1 etc beep code detail well thx4help
 

·
TSF Enthusiast
Joined
·
1,153 Posts
Hi and thanks for the update….

As Tyree has stated that beep sequence is usually the RAM. If you remove the RAM completely from the system and power it on, do you get the same beep sequences?

Thanks!
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top