If it still goes down but not up you can try to open and close the manual release valve, it's located on the bottom (side) of the trim pump on the starboard side, straight slot screwdriver, do not over tighten! If there's no above normal friction in the tilting of the engine then most likely the pistons have too much friction or the valve body is defective.
Johnson outboard 90
Help
Tilt is fine going down, stopped coming up... when it tries to raise it makes the same noise, but no movement...
Any suggestions please?
Thank you
Anna
Tilt is fine going down, stopped coming up... when it tries to raise it makes the same noise, but no movement...
Any suggestions please?
Thank you
Anna
- Status
- Not open for further replies.
1 - 1 of 2 Posts
1 - 1 of 2 Posts
- Status
- Not open for further replies.
Tech Support Forum
A forum community dedicated to tech experts and enthusiasts. Come join the discussion about articles, computer security, Mac, Microsoft, Linux, hardware, networking, gaming, reviews, accessories, and more!
Full Forum Listing
Recommended Communities
