Tech Support Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a heat only boiler for under slab heating. The heating zones are now on old two wire mercury contact tstats. Luckily the original installer used 3 wire cabling but left the third wire unused.
If the needed C wire for a smart tstat is actually a 24 volt comon wire, could the unused third wire be connected to the C terminal in a new wifi tstat and connected to the 24 volt common at the boiler to supply 24v constant power to the wifi tstat?
 
1 - 1 of 1 Posts
Top