Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Global Moderator
Electronic Design
Joined
·
52,196 Posts
The most common reason for this message is a disk controller that is not natively supported by W2K. Is this a Promise IDE controller, SCSI controller or similar by some chance? If so, you need to load the drivers early in the installation by hitting F6 at the prompt. For the Promise IDE, you can also move the disk connection to the standard IDE connection, install, install drivers, and then move it back to the Promise Controller connection.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top