Tech Support Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am in the process of replacing bad capacitors on the HP vs17x. I have removed all the screws from the top of the circuit board but there is still a whitish colored piece of plastic in the corner that connects the circuit board to the casing. How can I safely remove this and put it in place when I'm done? Also if there is anything I should know before proceeding, I would appreciate that information also. I don't have much experience in repairing hardware but this seems to be a relatively easy fix.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
From what I hear, the HP vs17x monitor is notorious for bad capacitors. Hasn't anyone had this problem before? I would think this would be somewhat of a generic issue.
 

·
Moderator; Hardware
Joined
·
19,884 Posts
It may be a common issue, but we don't typically deal with 3M type repairs. We mostly deal with card level troubleshooting, not component level.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top