Tech Support Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,

I hope someone can guide me in the right direction.
I am setting up an nfs failover node.
The NFS servers share out mounts to a SAN.

My problem is this: the master node has
emcpowera as the 100 gig partition
emcpowerb as the 200 gig partition
emcpowerc as the 300 gig partition

and the failover node has

emcpowerc as the 100 gig partition
emcpowerb as the 200 gig partition
emcpowera as the 300 gig partition

This is no problem until the failover node takes over the duties of nfs.
The nfs clients that were connected to the share that maps to emcpowerc on the master now for some reason map to emcpowera.

I had a look and see that powermt is responsible for the pseudo naming of the devices.
How do I cahnge the pseudo names for the SAN on the failover node to match the Primary nodes??

ANy helpo will be most appreciated.

Thank you
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top