[a riopelle]

Hi all if the subs are 4 omb can i hook them up to 2 omb to get more rms watt power

 

[a riopelle]

Hi again on hooking up my 2 sub's can i hook them up by 1 channel instead of 2 cannel and if i can how do i do it i need more Rms watt is it possable

 

[carsey]

Yes, if the subs are exactly the same, and your amp can give the required RMS to power the subs, then yes you can.

 

[a riopelle]

how do i do it

 

[a riopelle]

or can i go to 1 channel

 

[carsey]

Well it depends what your amp gives out at bridged and per channel. Bridged always gives you more power, but you need to know if it can run at 2 ohms or whatever.

http://www.crutchfield.com/S-cGQyX6W525M/Learn/learningcenter/car/subwoofers_wiring.html

 

[lcurle]

2 SVC 4 ohm subs will produce a 2 ohm draw from the amp. 2 DVC 4 ohm subs will produce a 1 ohm load. 2 DVC, @ ohm subs will produce a .5 ohm load....etc etc Run them bridged on the amp if the amp is stable with said load.

 

[a riopelle]

so if the amp is a mono amp can i run out of the amp to 1 speaker then to the second speaker or how do i do it

 

[mporettim]

what amp and subs do you have or are you looking at?

 

[lcurle]

if an amp is a mono amp that means 1 channel, and you have to find out if it is 1 ohm, 2 ohm or 4 ohm stable to determin the wire configuration.