Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hello all,
I just recently put together a P4 1.7 423 pin with 384 RIMM.While trying to load XP I am getting the error message "DRIVER_IRQL_NOT_LESS_OR_EQUAL" and the only way I can get around it is to disable the cache in the BIOS and the install doesnt seem to want to go...I have been going crazy trying to figure out what is going on here and am not cominh up with much of a conclusion....Any help or suggestions as to what may cause this and how to correct it would be greatly appreciated.......Thanks
 

·
Premium Member
Joined
·
1,611 Posts
Is this a BSOD error with a stop code ? ...after looking around on MS website, I found this :



SYMPTOMS
You may receive the following error message on a blue screen:

STOP 0x000000D1 DRIVER_IRQL_NOT_LESS_OR_EQUAL

Parameters
1 - memory that is referenced
2 - IRQL
3 - value 0 = read operation, 1 = write operation
4 - address that referenced memory

CAUSE
This issue can occur when the Driver Verifier feature is enabled and a driver has used an improper address. Note that the driver that is causing this issue may be listed in the error message.

RESOLUTION

To resolve this issue:
Disable all third-party filter drivers, such as backup programs, virus scanning programs, and disk utilities.

Make sure that you are using hardware that appears on the Windows Hardware Compatibility List (HCL). To view the latest Windows HCL, visit the following Microsoft Web site:

http://www.microsoft.com/hwdq/hcl/

hope this helps !!!
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top