Tech Support Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
18 Posts
Discussion Starter · #1 · (Edited)
Good day guys,
Recently I am working on RC oscillator circuit according to this note, but I had problems with adjusting frequency. I can adjust frequency but it effects amplitude too (amplitude is changing while adjusting frequency), how can i separate these two variables ? I mean, when I am adjusting frequency, I want to amplitude remains same, and also for amplitude too. By the way I am using this circuit : (Ignore the opamp circuit, it is converting sinusoidal wave into square wave.)
Product Rectangle Slope Font Parallel

Is there anyone have ideas of it? Thank you in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top