Tech Support banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi, Im having troubles with my 3DForce FX5200 LE 128mb, I have a Windows xp, AMD Duron 892 mhz, 376mb of ram, Amptron motherboard 1200+ with a SiS chipset.

Now what i did to install it was i turned my computer off and the montor then i put the card in the agp slot connected my monitor to it (plug and play) then i turn my computer on and it way looking ok i just had to fix the resolution, and the problem was the monitor kept goin into standby mode after about 6 minutes just the monitor then ill reboot my computer and it would come back on for for about 6 mins then will go off and i would have to restart my computer again i did this like 5 times then i just pluged my monitor back into the onboard card and took the FX5200 out, and now its my comprter doing fine again with the onboard SiS.

Can u help me please

Thanks:confused:
 

·
Registered
Joined
·
277 Posts
had a similar problem with windows 95, windows handled standby so did the BIOs, so system was deadlocked, to fix the prob, i disabled the windows controls to standy
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top