Tech Support banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
FastTrakController ????

i have an

asus p4c800 mobo and a
p4 2.4 GHz cpu.
ati "all in wonder" 9000 pro vidoe card
corsair twin 512mb RAM

this is my first time building a computer. when i boot up the comp this is the message i get...


NO drive attached to FastTrakController...and No bios installed...
then it just shuts down.

i dont know what is going on here. pls help.
 
S

·
Guest
Joined
·
0 Posts
Welcome initialauto..................:D

It's trying to boot to your Raid controller! Read the manual and disable it.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Hey thanks for the info. my comp actually works now. i disabled the Raid, and updated the bios, and uhh what else did i do, oh i only clamped down one of the retainers on the heatsink and all is well. well i get 3 beeps but i can still use my comp. i'm actually writing to you from my new comp. i'd just like to thank this whole forum b/c it's been a great help.
 
S

·
Guest
Joined
·
0 Posts
If you have three USB items connected to that motherboard then I think three beeps may be correct. Again check with the manual or their website on beep codes........:D
 

·
Registered
Joined
·
37 Posts
If theres a speaker at the bottom of your case - disconnect it from the mobo and no more beeping EVER!! xD
 
S

·
Guest
Joined
·
0 Posts
If theres a speaker at the bottom of your case - disconnect it from the mobo and no more beeping EVER
That's a good solution. Kind of like if you get a flat on your car just take the tires off and throw them away, Wallah no more flats.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top