Tech Support Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi guys. May I ask, if I plugged the scanner to a 220v outlet instead of a 110v accidentally and switchee it on, is it still repairable? Didnt realize that the scanner was a 110v.

Any answer is helpful. Thank you!
 

· Team Manager, Microsoft Support
Joined
·
33,976 Posts
Probably fried. I did that with a portable grinder when I was 12 years old. It set a new RPM record for about 5 seconds, then became an odd looking doorstop.

331121
 

· Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Probably fried. I did that with a portable grinder when I was 12 years old. It set a new RPM record for about 5 seconds, then became an odd looking doorstop.

View attachment 331121
That's one mean looking doorstop. Haha Thanks for the info! Hopefully someone thinks or knows its still fixable. It would be hard looking for a new one with that model here in my country. Very sad. I should've checked that it may be 110v. Forgot that those things existed. Oh well. Hind sight is 20/20. I owe my gf a nice scanner for film scanning.
 

· Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
The outlet and plug are not the same. We are just used to using an adpater everytime the plugs are different. Forgot there was a time that not every/most of the appliances are 220v. My gf was so excited in trying out the scanner. It was her dream to scan negatives. Its a sad day. Its a lesson for me to always check the power rating.
 

· TSF Moderator , Hardware Team , Networking Team
Joined
·
12,043 Posts
You might check to see if it had a built-in protection device, such as a fuse. If it does, replace the fuse and then give it another try (on 110V of course).
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top